The New Version of RFHelper for Optical Fiber Fence Was Released Successfully!

Recently, Raycom successfully released a new version of RFHelper software. RFHelper is the specific debug software developed to configure and manage our RF900 series, RF960-X series and RF960 system. By configuring the work parameters of each zone, the intrusion detection system can perform ideal work status.
The main update items are as follows:
1、    Redivide application types. 
    The underground application is divided into three types.
    Above ground application is divided into 7 types, among which “In Door DEMO” type is specially added, which will be easier for you to adjust the parameters when you show it in the lab.
2、    For each type of application, the software gives a different default configuration.
    when you select one application, the corresponding default parameters will be automatically loaded, In most cases, users only need to adjust a few parameters, which will reduce lots of work for you.
3、Redivide the parameters
RFHelper provides above ground and under ground mode, in above ground mode, there are two sets of detector: intrusion detector and net cutting detector. The parameters of the intrusion detector can be summarized into five levels: Basic processing layer, Signal processing layer,  Background processing layer,  Event processing layer and Behavior processing layer . 
4、    Put more parameters into the advanced mode, 
These parameters will be automatically changed to the appropriate value, which will be no need to change again. 
5、    Change some parameters name, which is easier to be understood.
6、    Each parameter is simplified, so that the interface is simple, the mouse can appear on the full name