• HIFI Audio Optical Transceiver

        ● RV6X4-2A         2-ch unidirectional HIFI
        ● RV6X4-4A         4-ch unidirectional HIFI
        ● RV6X4-4A-1U    4-ch unidirectional HIFI-1U
        ● RV6X4-8A         8-ch unidirectional HIFI
        ● RV6X4-2A-2BA   2-ch bidirectional HIFI
        ● RV6X4-4A-4BA   4-ch bidirectional HIFI

        ● Compact design with 1U height
        ● XLR interface for Audio
        ● SNR is better than 92dB
        ● 192K sampling frequency
        ● 24 bit quantized accuracy
        ● Provides AC110~220V dual power redundancy

      • SDI Converter

        ● 75ΩBNC connector for SDI input and looping out
        ● VGA output interface
        ● Two unbalanced RCA audio output with 600Ω impendence...

        ● Features 1 VGA input, 2 audio inputs and 1 SDI output
        ● Supports asymmetrical conversion for any format
        ● The input and output video format can be shown on the screen...

        75Ω BNC connector for SDI input and looping out

        ● HDMI output interface

        ● Two unbalanced RCA audio output with 600Ω impendence...

      • SDI Distribution Amplifier

      • 4U Rack Mounting Chassis

        ● 19 inch and 4U height
        ● 16 traffic card slots and 1 management card slot
        ● 3 fans embedded
        ● Dual power supplies for power redundant protection
        ● Provides one RS232 management interface(CONSOLE) used for CLI management...

      • HD-SDI Surge Protector

        and Pattern Generator

        ● Multi-level protection, low residual voltage
        ● Short response time   
        ● Large thermal capability and low limiting voltage
        ● Stable performance and long service life...

        ● Comply with SMPTE-424M 3G-SDI, SMPTE-292M HD-SDI and SMPTE-259M SD-SDI standard
        ● Support 1080P@59.94/29.97, 1080I@59.94, 720P@59.94, 525I@59.95 format of NTSC...

      • Fiber Optic Intrusion Detection System

      • Fiber Optic Intrusion Detection System Solution

      • Fiber Optic Intrusion Detection System Classic Case Series

      • Fiber Optic Intrusion Detection System Video Introduction

      • CHIP

      • Multi-Service Access Platform

        3U height, 19 Inch width standard, 9 card slots.

        Up to 2 GE optical ports and 2 GE electrical ports

        Aggregate the 1000M Ethernet traffic from up to 3 downlink cards...

        ● 7U height, 19 Inch width standard, 16 card slots.

        ● Up to 4 GE optical ports and 4 GE electrical ports.

        ● Each card can aggregate the 1000M Ethernet traffic from up to 8 downlink cards...

      • Converter

      • Compact SDH

      • Compact PDH

      • Channelized Industrial Ethernet switch

        Optical interface
        ● Two optical interfaces; SFP optical module (LC interface); Hot plugging...
        Ethernet interface
        ● RP105SA:One fiber and two copper Gigabit Ethernet interfaces
        ● RP106: Four fast Ethernet interfaces...


Refinery solutions

According to the customer's description, a set of protective device needs to be installed around the system. The system is required to be able to prevent the illegal invasion of the outside world for 24 hours, providing a safe and harmonious environment. It is required that the detection unit laid on the medium can sense the intrusion signal immediately once any illegal person attempts to intrude.

● Download the password, please consult customer service





     According to the customer's description, a set of protective device needs to be installed around the system. The system is required to be able to prevent the illegal invasion of the outside world for 24 hours, providing a safe and harmonious environment. It is required that the detection unit laid on the medium can sense the intrusion signal immediately once any illegal person attempts to intrude. And timely transmit the intrusion signal to the alarm host in the machine room.

    1) the whole system can be set up at any position without sensing area to avoid the area without fortification on site. (gate, pavement, etc.)

    2) it can realize the linkage with the back-end video.

    3) the system can run independently from PC; in case of PC failure, the whole intrusion detection system can still send out alarm signal.

    4) the system supports the application of loop protection. When a sensing optical cable in a defense area is broken, there is no impact on other defense areas on both sides of the broken cable, and intrusion alarms can still be detected in other defense areas.

    The perimeter of the refinery is 2-meter-high fence with rolling net, and the perimeter of the fence is about 2000 meters. The length of the defense area is divided according to the actual situation of the site, and a total of 16 defense areas are set up. Each defense area is set as a hanging net protection mode, and the system defense area topology is shown in the following figure


    Equipment linkage management

    When a perimeter protection system has more defense areas, or there are video monitoring devices (such as cameras, DVR / NVR) in the system, it is necessary to consider how to integrate the system and other types of perimeter protection systems into a whole.

    In this case, you can connect the Ethernet interface of rf960 through LAN, establish the connection with PC, and install rfview management software on PC. Rfview collects the alarm events of each defense area, outputs them to the RS232 or RS485 interface of PC, and then uses the external serial port to the switch converter to convert the serial communication protocol to the switch value, and finally connects the switch value to DVR / NVR to realize the linkage with the camera. The linkage mentioned here can be to switch the relevant video picture of the intrusion event to a prominent position, or to drive PTZ immediately after the event, and the camera to the appropriate preset position to observe the event scene.



Other  Products


Contact us