CN | EN

      • Fiber Optic Intrusion Detection System

      • Fiber Optic Intrusion Detection System Solution

      • Fiber Optic Intrusion Detection System Classic Case Series

      • Fiber Optic Intrusion Detection System Video Introduction

    • HD-SDI Surge Protector
      RV705 HD-SDI Surge Protector

      4U Rack Mounting Chassis
      RV600C HD-SDI 4U Rack Mounting Chassis

      4U Rack Mounting Chassis
      RV600C HD-SDI 4U Rack Mounting Chassis

      HD-SDI Surge Protector
      RV705 HD-SDI Surge Protector

      • HIFI Audio Optical Transceiver

        ● RV6X4-2A         2-ch unidirectional HIFI
        ● RV6X4-4A         4-ch unidirectional HIFI
        ● RV6X4-4A-1U    4-ch unidirectional HIFI-1U
        ● RV6X4-8A         8-ch unidirectional HIFI
        ● RV6X4-2A-2BA   2-ch bidirectional HIFI
        ● RV6X4-4A-4BA   4-ch bidirectional HIFI

        ● Compact design with 1U height
        ● XLR interface for Audio
        ● SNR is better than 92dB
        ● 192K sampling frequency
        ● 24 bit quantized accuracy
        ● Provides AC110~220V dual power redundancy

      • SDI Converter

        ● 75ΩBNC connector for SDI input and looping out
        ● VGA output interface
        ● Two unbalanced RCA audio output with 600Ω impendence...

        ● Features 1 VGA input, 2 audio inputs and 1 SDI output
        ● Supports asymmetrical conversion for any format
        ● The input and output video format can be shown on the screen...

        75Ω BNC connector for SDI input and looping out

        ● HDMI output interface

        ● Two unbalanced RCA audio output with 600Ω impendence...

      • SDI Distribution Amplifier

      • 4U Rack Mounting Chassis

        ● 19 inch and 4U height
        ● 16 traffic card slots and 1 management card slot
        ● 3 fans embedded
        ● Dual power supplies for power redundant protection
        ● Provides one RS232 management interface(CONSOLE) used for CLI management...

      • HD-SDI Surge Protector

        and Pattern Generator

        ● Multi-level protection, low residual voltage
        ● Short response time   
        ● Large thermal capability and low limiting voltage
        ● Stable performance and long service life...

        ● Comply with SMPTE-424M 3G-SDI, SMPTE-292M HD-SDI and SMPTE-259M SD-SDI standard
        ● Support 1080P@59.94/29.97, 1080I@59.94, 720P@59.94, 525I@59.95 format of NTSC...

      • CHIP

      • Multi-Service Access Platform

        3U height, 19 Inch width standard, 9 card slots.

        Up to 2 GE optical ports and 2 GE electrical ports

        Aggregate the 1000M Ethernet traffic from up to 3 downlink cards...

        ● 7U height, 19 Inch width standard, 16 card slots.

        ● Up to 4 GE optical ports and 4 GE electrical ports.

        ● Each card can aggregate the 1000M Ethernet traffic from up to 8 downlink cards...

      • Converter

      • Compact SDH

      • Compact PDH

      • Channelized Industrial Ethernet switch

        Optical interface
        ● Two optical interfaces; SFP optical module (LC interface); Hot plugging...
        Ethernet interface
        ● RP105SA:One fiber and two copper Gigabit Ethernet interfaces
        ● RP106: Four fast Ethernet interfaces...

    • CONTACT US

    • Mobile: 86-13810132168
    • Tel: 86-10-80106100-157
    • Skype ID
    • live:d8d61896f81afc11
    • 服务时间

    • 周一至周五 9:00-18:00
    • WeChat qr code

  • Multi-functional Ethernet converter (RC7222A2)

    The RC7222A2 is a highly integrated ASIC chip for data conversion from 10M/100M Ethernet and ST_BUS to WAN interfaces (E1/FE1, or SSI*). It supports E1/FE1 and MII interfaces that follow ITU-T standards.


    180 ¥ 0.00
  • Monolithic SDH TM/PHY Multiplexer and Mapper (RC7883A1)

    RC7883A1 is a low price product designed on the basis of RC7880A1, The core design and package of RC7883A1 is the same with that of RC7880A1. RC7883A1 provides three kinds of application modes: TM mode, PHY mode and MAP mode. The three modes can be configured by register.

    174 ¥ 0.00
  • 155M ADM multiplex processor (RC7860)

    The RC7860 is a 155M dual-optical-port multiplexer, supporting STM-1 overhead processing, TUPP and simple DXC function. The RC7860 is designed for SDH ADM/TM multiplexer or SDH tester.


    126 ¥ 0.00
  • Monolithic SDH ADM Multiplexe (RC7880A1)

    RC7880A1 is a monolithic SDH Add/Drop multiplexer which multiplexes 24 E1s to dual STM-1 optical line interfaces. With a few external components, the STM-1 ADM equipment can be realized. RC7880A1 can be used as a Customer Premises Equipment (CPE), an Add-Drop-Multiplexer (ADM) or Multi-Service Access platform equipment (MSAP) to build various transmission networks.

    119 ¥ 0.00
  • 100M Ethernet & 8E1 merging multiplexer (RC7017A2)

    The RC7017A2 is a mixed multiplexer, which integrates a PDH optical terminal and a 100BASE-FX Ethernet PHY transceiver. It transmits and receives 8 E1 and 100M full-speed full-duplex Ethernet data through a pair of optical fiber, and provides two Pseudo-CML (PCML) optical device interfaces to support optical protect switching.

    160 ¥ 0.00
  • Multi-Service Converter (RC7235A2)

    The RC7235A2 is the updated revision of RC7235, and can be applied to E1 fiber modem, multi-service fiber modem, multi-service E1 converter or multi-service ST-BUS converter. The RC7235A2 has V.35/FE1/STDW-BUS/HDLC interface on user port and optical/E1/ST-BUS interface on line port. The STDW-BUS interface can realize data and voice complex access. The RC7235A2 provides two configuration modes...

    144 ¥ 0.00
  • Gigabit Ethernet & 16-E1 ADM Multiplexer (RC7020)

    Targeted at ADM applications, the RC7020 multiplexes a Gigabit Ethernet line with 88 E1 lines over a 1.25Gb/s optical fiber. The RC7020 provides dual 1.25Gb/s optical ports and dual GMII interfaces for interfacing to external switches. E1 and Ethernet traffic are protected with rapid protection switching in a ring network topology when a fault occurs. The RC7020 incorporates an HDLC controller ...

    199 ¥ 0.00
  • 16E1 EOPDH Converter (RC6116)

    RC6116 is a highly integrated device implements Ethernet frame transmission over 1~16 E1 links. Compliant to international standards, the device can communicate with products from other manufacturers adopting the same standards.

    190 ¥ 0.00
  • Multi-port Eos Mapper (RC6400)

    RC6400 is a highly integrated EOS device that provides for mapping of 4 Ethernet ports into SDH transport payloads. Complying with ITU-T standards, RC6400 adopts GFP-F encapsulation, low-order virtual concatenation (VCAT) and link capacity adjust scheme (LCAS). The device can communicate with products from other manufactures adopting the same standards.

    174 ¥ 0.00
  • 16 Channel Ethernet over TDM Mapper (RC6630A1)

    The RC6630A1 is designed to aggregate Ethernet traffic from 16 directions through TDM networks. The 16 physically isolated VCG (Virtual Container Group) correspond to 16 remote terminals. RC6630A1 can be configured as EoPDH mode or EoS mode, and the container is E1 for EoPDH and VC-12 for EoS respectively. and the bandwidth of each VCG can be configured...

    181 ¥ 0.00
  • 5E1 EOPDH Converter (RC6105)

    RC6105 is a highly integrated device implements Ethernet frame transmission over 1~5 E1 links. Compliant to international standards, the device can communicate with products from other manufacturers adopting the same standards.

    128 ¥ 0.00
  • Centralized MSAP (RS7000)

    RS7000 is the centralized Multi-Service Access Platform (MSAP) compatible with ITU-T standard. It is designed as a cost-effective and flexible multi-service platform, with STM-1 / STM-4/STM-16 level uplink ports and abundant optional downlink cards to provide typical E1 traffic, PCM, optical tributary, EoSDH and EoPDH traffic access and aggregate...

    330 ¥ 0.00

Other  Products

PRODUCTS