Multi-service Optical Terminal（RS1030N)

Overview   

 RS1030N is designed as a modular system with two 155Mb/s optical interfaces to provide an ultra-compact, cost-effective and flexible multi-service platform. With optional cards such as E1 card and Ethernet card, it is easy to meet user’s various requirements. It can realize the 4/8/16E1 and 100Mbps Ethernet transmission over optical line.

With low power consumption, high integration and well stability, RS1030N can be used to build point-to-point network; it is a cost-competitive solution for the application such as the telecommunication, the electric power and the finance fields.

Feature

• Standard rack with 1U height and 19 Inch width
• Optical Interface
• Two 155Mb/s optical interfaces, LC type SFP module, hot pluggable
• Provides optical line 1+1 protection with switching time less than 50ms
• Supports RPD (Remote Power down Detection) information sending function
• Supports ALS (Automatic Laser Shutdown) to protect operators from hurt
• Local equipment supports optical line loop and device loop, remote equipment supports optical line loop
• E1 Interface
• Provides 4/8/16 E1 interfaces
• Optional 120Ω balanced E1 interface / 75Ω unbalanced E1 interface
• E1 interface, Jitter tolerance and jitter generation fully comply with ITU-T G.703, G.823 recommendations.
• Supports E1 device loop and E1 line loop for easy testing.
• Ethernet Interface
• Provides 4 copper fast Ethernet interfaces
• Four Ethernet ports share 100Mbps
• Supports auto-negotiation, it can also be set to 10M full/half-duplex, 100M full/half-duplex mode by force
• Accepts frames with length between 64 and 1518/1916 bytes (otherwise filtering).
• VLAN function based on tags compliant to IEEE 802.1Q.
• Up to 16 VLAN entries
• Supports MAC address dynamic learning
• Auto MDI/MDX function.
• Supports Link Fault Pass Through function
• Throughout statistic of the Ethernet packets based on port
• Supports flow control and broadcast storm filtering control.
• Supports port rate control.
• Equipment timing mode
• Tracing from local timing
• Tracing from Optical line
• Tracing from E1 line
• Supports embedded BERT for troubleshooting
• Management
• Provides serial management interface(CONSOLE) and Ethernet management interface (EMU), both adopt RJ45 connector
• Supports local management based on CLI command via CONSOLE interface or Telnet login
• Supports local management based on WEB Browser login via local management interface (EMU)
• Supports RayView network management platform based on SNMP_V1 and SNMP_V2 protocol to perform excellent management
• Supports firmware update online by remote control

Application

RS1030N can be used to build point-to-point network, the four Ethernet ports share 100Mb/s, as the following figure shows:

Figure 1 Application