• HIFI Audio Optical Transceiver

        ● RV6X4-2A         2-ch unidirectional HIFI
        ● RV6X4-4A         4-ch unidirectional HIFI
        ● RV6X4-4A-1U    4-ch unidirectional HIFI-1U
        ● RV6X4-8A         8-ch unidirectional HIFI
        ● RV6X4-2A-2BA   2-ch bidirectional HIFI
        ● RV6X4-4A-4BA   4-ch bidirectional HIFI

        ● Compact design with 1U height
        ● XLR interface for Audio
        ● SNR is better than 92dB
        ● 192K sampling frequency
        ● 24 bit quantized accuracy
        ● Provides AC110~220V dual power redundancy

      • SDI Converter

        ● 75ΩBNC connector for SDI input and looping out
        ● VGA output interface
        ● Two unbalanced RCA audio output with 600Ω impendence...

        ● Features 1 VGA input, 2 audio inputs and 1 SDI output
        ● Supports asymmetrical conversion for any format
        ● The input and output video format can be shown on the screen...

        ● 75Ω BNC connector for SDI input and looping out

        ● HDMI output interface

        ● Two unbalanced RCA audio output with 600Ω impendence...

      • SDI Distribution Amplifier

      • 4U Rack Mounting Chassis

        ● 19 inch and 4U height
        ● 16 traffic card slots and 1 management card slot
        ● 3 fans embedded
        ● Dual power supplies for power redundant protection
        ● Provides one RS232 management interface(CONSOLE) used for CLI management...

      • HD-SDI Surge Protector

        and Pattern Generator

        ● Multi-level protection, low residual voltage
        ● Short response time   
        ● Large thermal capability and low limiting voltage
        ● Stable performance and long service life...

        ● Comply with SMPTE-424M 3G-SDI, SMPTE-292M HD-SDI and SMPTE-259M SD-SDI standard
        ● Support 1080P@59.94/29.97, 1080I@59.94, 720P@59.94, 525I@59.95 format of NTSC...

      • Fiber Optic Intrusion Detection System

      • Fiber Optic Intrusion Detection System Solution

      • Fiber Optic Intrusion Detection System Classic Case Series

      • Fiber Optic Intrusion Detection System Video Introduction

      • CHIP

      • Multi-Service Access Platform

        ● 3U height, 19 Inch width standard, 9 card slots.

        ● Up to 2 GE optical ports and 2 GE electrical ports

        ● Aggregate the 1000M Ethernet traffic from up to 3 downlink cards...

        ● 7U height, 19 Inch width standard, 16 card slots.

        ● Up to 4 GE optical ports and 4 GE electrical ports.

        ● Each card can aggregate the 1000M Ethernet traffic from up to 8 downlink cards...

      • Converter

      • Compact SDH

      • Compact PDH

      • Channelized Industrial Ethernet switch

        Optical interface
        ● Two optical interfaces; SFP optical module (LC interface); Hot plugging...
        Ethernet interface
        ● RP105SA:One fiber and two copper Gigabit Ethernet interfaces
        ● RP106: Four fast Ethernet interfaces...

  • Compact Gigabit Ethernet Aggregator (RB002)

    RB002 is a Gigabit Ethernet aggregator with inverse multiplexing and VLAN TAG function,it provides three gigabitEthernet interfaces (2 electrical and 1 optical Ethernet interfaces) compliant with IEEE 802.3 series standard and 2STM-1 interfaces. It can separate the Ethernet data from GE port (the carried VLAN Tagcorrespond to different VCGchannels)...

    넶256 ¥ 0.00

  • E1 Optical Modem-RB-MO

    E1 Optical Modem can realize transmission of one path of 2.048Mb/s signal over a pair of optical fibers. Based on the ASIC chips, this system was designed with inner modularized structure, and it integrates the coding, decoding, message insertion, and alarm switching functions. With the characters of simple hardware structure, compact and low power con-sumption...

    넶277 ¥ 0.00

  • REOP Ethernet to Multi-E1 converter (REOP)

    REOP is the IP over TDM converter, which supports the conversion from MAC frames to 1 – 16 E1 lines. The maximum bit rate is 31.68Mbps (16E1 lines). With different LAN card, E1 card and power card, it can meet various requirements. It not only provides alarms and status of the E1 line and Ethernet interface together with advanced management functions, such as, throughput statistic of the Ethernet.

    넶300 ¥ 0.00

  • Ethernet to E1 Converter (RB004)

    RB004 is an Ethernet to E1 converter with one copper fast Ethernet interface and one 75Ω/120Ω E1 interface*. It is featured by ultra-compact, cost-effective and low power consumption, which is ideal for application areas such as network access, transparent LAN service and LAN extension.Note that the 75Ω/120Ω impedance is optional, which should be declared before order.

    넶222 ¥ 0.00

  • Optical Ethernet to E1 Converter (RB005)

    RB005 is an Ethernet to E1 converter with one fiber fast Ethernet interface and one 75Ω/120Ω E1 interface*. It is featured by ultra-compact, cost-effective and low power consumption, which is ideal for application areas such as network access, transparent LAN service and LAN extension.

    넶277 ¥ 0.00

  • Ethernet to E1 Converter (RB007)

    RB007 is an Ethernet to E1 converter with 4 copper fast Ethernet interfaces and one 75Ω&120Ω E1 interface, supports CLI command and SNMP_V1&V2 protocol to perform perfect management functions. It is featured by ultra-compact, cost-effective and low power consumption, which is ideal for application areas such as network access, transparent LAN service and LAN extension.

    넶301 ¥ 0.00

  • RB008 Dual-VCG channel Gigabit Ethernet Converter (RB008)

    RB008 is a dual - VCG channel Gigabit Ethernet Converter, provides 4 gigabit Ethernet interfaces (3 copper and 1 fiber Ethernet interfaces) compliant with IEEE 802.3 series standard and 2 STM-1 optical interfaces, supports 1+1 optical path protection and 2+0 mode. In 1+1 mode, the 4 Etherent interfaces share one VCG and the bandwidth is one VC4 (139Mb/s). In 2+0 mode...

    넶290 ¥ 0.00

  • Gigabit Ethernet to STM-4 Converter (RB006)

    RB006 is the compact and high-performance Gigabit Ethernet to STM-4 converter with VLAN TAG function, which provides three gigabit Ethernet interfaces (2 electrical and 1 optical Ethernet interfaces) and 2 STM-4 interfaces. By adopting ITU-T G.7041 and G.7042-compliant EoSDH (Ethernet over SDH) technology, RB006 provides one VCG whose bandwidth can be flexibly configured from 1~8 VC4.

    넶279 ¥ 0.00

  • Compact Gigabit Ethernet Aggregator (RB009)

    RB009 is a Gigabit Ethernet aggregator with inverse multiplexing and VLAN TAG function; it provides three gigabit Ethernet interfaces (2 electrical and 1 optical Ethernet interfaces) compliant with IEEE 802.3 series standard and up to 24 E1 interfaces. It can separate the Ethernet data from GE port (the carried VLAN Tag correspond to different VCG channels), encapsulate them into EoPDH signal.

    넶362 ¥ 0.00

  • Simplified Ethernet to multi-E1 Converter (RB003)

    The RB003 series is the IP over TDM converter, which supports the conversion from MAC frames to 1 – 16 E1 lines. The maximum bit rate is 31.68Mbps (16E1 lines). It not only provides alarms and status of the E1 line and Ethernet interface together with advanced management functions, but also supports the Local/ remote monitor and management via CLI commands. With low power consumption.

    넶227 ¥ 0.00

Other  Products

넳 넲

PRODUCTS